I purchased both L & R headlamp assemblies a few weeks ago and with a little help replaced both units in a couple hours. Everything fit perfect but it was some trouble to access the outboard screw that held the assembly to the fender. You must remove a portion of the plastic fender liner at the forward part of the wheel well. Remove a screw and pull out the lower part of the bumper. By doing this you can access the bolt (screw) that holds the lamp assembly. I took the plastic fender liner out but this is not necessary. The bumper will move out a few inches so you can get a deep well socket in the hole. You also must remove the plastic piece that covers the front section under the hold.. This will expose three (3) screws
How often do you shop at JC Whitney.com?Multiple Times a Year
good value for the price
PostedApril 15, 2016
Consnot high quality
I received the package on time, but one of the headlight adjusters was broken and I had to use the old one. they were a perfect fit, and they cost a lot less than what the dealer was charging for the same headlights.